Rainbow Vacuum E2 Type 12 Silver Series v2 Motor Parts - Page 2

Base bearing sub assembly for the two speed E2 Type 12 (e2 Black, Silver, Gold) Rainbow vacuum motor. Comes with the bearing installed and works on all versions of the "Hurricane" motor.

The lower motor housing completes the bottom half of all e2 two-speed motors. It is compatible with the E2 Type 12 (e2 Black, Silver, Gold) models.

Bearing bracket that came standard on the model E2 Type 12 (Black, Silver) series Rainbows. This is another improvement with the version 3 clamped upper bearing design. Version 2 of this item was item number R12894 and version 1 was...

Wave washer that sits on top of the rotor assembly. This fits the 2nd version motor (direct-support design). Effective serial number 1167460 with a start date of October 25th 2005 through serial number 1450000 (rough estimate) and an...

Encoder assembly for the two speed E2 Type 12 (Black, Silver, e2 Gold) Rainbow vacuum. The encoder is what switches the polarity for the "Hurricane" type motor that is installed in all 100-240 volt E2 Type 12 models.

This screw holds the encoder in place on all e2 two-speed motor designs and attaches directly to the motor base.

Standard field screw for all E2 Type 12 model Rainbows and all three version motors. This screw should almost never need to be replaced under normal wear and tear. If it does due to rust or corrosion, then please read the owner's...

This motor housing screw is used on all model E2 Type 12 Rainbows and all three version motors. This screw goes through the Base/Bearing Sub Assembly and attaches to the Bearing Bracket. Early production this part was silver, but...

This spacer helps keep all lower fans properly spaced in the motor to prevent the fans from hitting each other. It fits all e2 two-speed motors.

This spacer helps keep all upper fans properly spaced in the motor to prevent the fans from hitting each other. It fits all e2 two-speed motors.

This stator assembly is the heart of the e2 two-speed motor system by creating the suction needed for your Rainbow Vacuum.

The ground clip is used on the E2 Type 12 "Hurricane" motor design to ground the controller to the motor. Helps to eliminate static that can damage the controller board.